That's what I started with and I haven't had a chance to plug chop it down yet but at least I know I am rich and not lean.
porting
- Thread starter Arnold
- Start date
not yet I worked 12 hours on Saturday and worked on sunday too im tring to make a lil bit because I need some for when we drop the kx motor in the other frame I haveand I haven't had a time to toutch the blaster but I ll work on it some tonight
Last edited:
Dam! You lost a piston!! Hopefully u Didn't lose any of the smaller parts that go with it u.
I started last night the reason I dident get it done is because when I was putting the cir clips in the piston I bent one and got fed up with it and went in the house but iv got 4 to 6 laying around and I have also been polishing my head and I just got it done so hopefully it will be put toghter tonight
I trust that those clips you have laying around are not used ones, I have seen so much carnage caused by migrating piston pin clips.
no I have some used ones but I guess ill head up to slones to get some after I get the ball joints put in my truck
motor is put toghter waiting for the ultra copper to dry if there is no more air leaks I will post some videos up of it running tomorrow
got it running todat I put another head I had on it and it runs good but its compression is a lil low it is at 90 psi
got all of the heat cycles done today and I rode it and it seems like it has quite a bit more power than before I may have some vids sunday if im not doing any thing
