I need some information about blaster's engine parts.

[Alex m]

Hello everybody!I am a new member and I find this place very interesting!I:I
I own an old dt200 37f.This model's engine is very similar to blaster's 200 engine.
Please I would like to now the dimensions of the Vito's Vitos stroker crankshaft +3mm and V-Force3 reed valve so as I can understand if they fit to the Dt's engine.
I hope you understand my English 8-|
Thanks!

 

[brandoz28]

the reeds will work for sure, but someone else will have to tell you about the crank. i'm fairly positive that the stroker crank WILL work though.

 

[bagds101]

i dont see why not. i think about the only difference if the dt has 5 head studs instead of 6 like the blaster. i think it has 5

 

[Alex m]

Thanks guys!
bagds101if you mean the studs on the intake this model (37f) has 4.
I found two types of V-force reed valve for the Blaster.One has 6 holes and the other has 4.I think second one fits butt I'm not sure.

 

[super noober]

i thought last time this came up someone said that one of the sides of the crank is a litle bit too big and needs to be adjusted to fit into a DT200

 

[bagds101]

i meant the head... that bolts onto the top of the jug. and i think the reeds with 6 holes is for a different top end like a high performance one

 

[Alex m]

I understand...
I think its the flywheel side.The cone of Blasters crankshaft is bigger than the dt's.
Should the crankcase be machined to fit the stroker crankshaft?

 

[Awk08]

mcdizzy.com has done the dt onto a blaster bottom swap, tons of info on there,
i can get you bolt to bolt dimensions of the intake tomorrow when i get home

 

[Alex m]

You mean here: Yamaha YFS200/DT200 - Yummie Yami, Upgrade The YFS; To Be The Best
He sad that the crankshaft, piston and associated parts are the same, although you'd need to specify which model you owned, much like car insurance and different models with similar parts.