Lets see your porting tools!

[slickerthanyou]

I was able to use my dremel to port match my toomey flange to the new motor! Worked awesome I love it! Still hacking up metal but nothing a six pack can't cure!!

 

[York Racing]

Nice setup slick. I use a similar Dremel.

 

[slickerthanyou]

Haven't touch a cylinder and probably wont, but this little thing is pretty awesome!

 

[York Racing]

They work great but I mostly use my battery powered smaller one to get into the ports.

 

[slickerthanyou]

Here is what I did- Opened up the motor side about 1.25mm to match the ported exhaust port! sh*tty pic, but there is a lip still where it meets the donut gasket.

 

[blasterbuddy200]

thats sweet, iv always wanted a dremel, always needed one at times but never had one, kinda spendy little things but they seem well worth it

 

[brandoz28]

Love my dremel, its smaller than that one though.

Good work on matching that flange, my power pros flange was so close to the same size as my WILDCARD ported cylinder that I didn't bother, but I did take special care to get it squared up as much as possible!

 

[Blaner]

I also did that, i thinks its very NB to match it up or else your new pipe is rather useless

 

[OConnor Racing]

Here's mine.

 

[slickerthanyou]

Here's mine.

HOLY CRAP! Ya think ya have enough???

 

[Surfrjag]

daaaaamn ken! looks like you have double of some things.. can i borow them? haha

 

[brandoz28]

Love all of the different angled hand pieces! There's a lot of money on that table!!!!!!!

 

[York Racing]

"You have to pay to play!" And by the looks of it, Ken paid lol

 

[slickerthanyou]

Here's mine.

What is that device in the middle by the wood??

 

[OConnor Racing]

It's called a jackhammer Slick. It has a small cam on top of it. The drive unit moves the cam so you get a back and forth motion. I use it to run small files, stones and paper.