Sooo my motors blown. FTL!!

[2000blasternewb]

Hey guys, so I bought a blaster yesterday. Well I didn't my brother did, but with my money. So they were riding it around today and all of the sudden BAM nothing. No compresion either when he pushes the kickstart down. So they get it back to the garage and drain the fluids, come to find out there was no oil in it at all to mix with the gas. So from the master experts here what do you think is most likely wrong. They will be tearing it apart tomorrow. Thanks everyone.

 

[03blasteryfs03]

stuck a ring
dam+n 15

 

[2000blasternewb]

hmm so how much does something like this usually run to fix?

what is dam+n 15?

 

[03blasteryfs03]

a wiseco piston kit is like 89 bucks and gaskets r like 29 bucks

 

[2000blasternewb]

aww sweet. even if mine is already bored .050 over??

 

[ron89]

ouch that sux. yea sounds like you stuck a ring if your lucky you could prolly get away with a hone and new piston/rings. but if the cylinder has any scratches i would just spend the money and get it bored to the next size.

 

[2000blasternewb]

i was thinking about go to a .060 over anyways.

 

[03blasteryfs03]

ya that would be a smart choice get wiseco they r forged and lighter so better revs

 

[2000blasternewb]

so if its just some bad rings it should be fairly cheap to fix then guys???

 

[03blasteryfs03]

ya like 140 or around there

 

[03blasteryfs03]

prob more cause u need it bored and honed .60 over

 

[2000blasternewb]

hey 03, so regardless of most conditions that the motor could be in do you think this kit will take care of it??

.060 over kit w/ gaskets.


Does anyone know hom much more power you will get from goin from a .050 to a .060 piston?

 

[blaster01]

hardley any..boring doesnat add much power if any at all

 

[super noober]

hey 03, so regardless of most conditions that the motor could be in do you think this kit will take care of it??

.060 over kit w/ gaskets.


Does anyone know hom much more power you will get from goin from a .050 to a .060 piston?

not much of a power gain, but that kit should get her done for ya. just gotta get someone to bore/crosshatch your cylinder.

 

[royalt67]

In of itself, a new oversize isn't really much, like the other guys said. However, I noticed a big improvement on mine just because it was fresh and had nice compression again.

 

[2000blasternewb]

sweet guys thank you for the help. im tryin to keep the cost down for now. thank you all