Rear end lifter (for lubricating chain, etc)

[killerke]

Hello,

I put something together
I tought it would be good to share it with you guys.

Just slide it under, press it down with your footh and pull the grabbar
simple as that , i made it with some scrap tubing

greetz

 

[Blaaster]

That is a neat little device, top marks.

Be wary as the skid protection is a little flimsy, it does pay to help the lift with the grab bar!

 

[killerke]

That is a neat little device, top marks.

Be wary as the skid protection is a little flimsy, it does pay to help the lift with the grab bar!

Thanks, yes it is easier to lift it when you pull the grabbar.

I'm gonna look for making 1 for the front also.

And if you take a bigger tube that is welded to the base, drill a hole in it, and then a tube that slides in and drill some more holes, you can make it adjustable xD

 

[Herpderplol]

for the front on a stock blaster would be easy.

if you ever give/sell them, you would have to keep in mind aftermarket setups like mine have suspension travel of at least 6 inches before the tires come off the ground

 

[bummer981]

Well done.

 

[killerke]

Well done.

thanks

 

[harley1-5]

nice,simple is better some times.I like it

 

[bummer981]

That is a neat little device, top marks.

Be wary as the skid protection is a little flimsy, it does pay to help the lift with the grab bar!

I find the stock skid plate quite rigid and lift the rear of my quad up by it all the time and never had a problem.

 

[Larry's Shee]

Nice job!!

I'm lazy, I use a floor jack. Under skid in back, + block of wood front.

 

[killerke]

Nice job!!

I'm lazy, I use a floor jack. Under skid in back, + block of wood front.

I used to do it like that, but the jack in not always available so i did this in a spare hour xD