do i have it straight

[89blaster89]

this is polishing procedure right? i have been reading up on polishing things. sand with 500 wet sand paper then 800 then 1000 then 1500 then keep going up until its as shiny as you want it. then polish the heck out of it with mothers then wahlah your done!? can you polish like a grab bar or anything thats aluminum? what about steel?

 

[motoman159]

this is polishing procedure right? i have been reading up on polishing things. sand with 500 wet sand paper then 800 then 1000 then 1500 then keep going up until its as shiny as you want it. then polish the heck out of it with mothers then wahlah your done!? can you polish like a grab bar or anything thats aluminum? what about steel?

Sounds about right! NO steel!

 

[89blaster89]

Sounds about right! NO steel!

are the grab bars steel??

 

[motoman159]

are the grab bars steel??

Don't think so!

 

[89blaster89]

Don't think so!

awesome! good i can polish it haha im on a polishing craze

 

[York Racing]

If it's painted its probably steel..... Stock is steel.

 

[89blaster89]

If it's painted its probably steel..... Stock is steel.

ahhh dangit 1515151

 

[York Racing]

ahhh dangit 1515151

Cases, throttle, brake and clutch lever, brake master cylinder, caliper, bar clamps, and I can't think of anything else.

 

[Paulie B]

You can polish steel but you have to seal it from rust afterwards.
I don't personally recommend it for our quads cause it will be hard to keep it sealed with all the washing, dirt, and grime.
Here's some I polished...