Blow up carnage and rebuild
- Thread starter 89blaster89
- Start date
that's not to bad, I may just go buy one from the shop, I don't have anyway to get cash onto my paypal account
If your PayPal is attached to a checking account just put the money in your checking account and use it straight from there. Works great!
Look on craigslist around pittsburgh, If you find one, I can get it and ship it to you. Just pay me back!!! lol
i only found the re assembly KOR video, when I split the cases what side do I do it on? I don't want the gears to fall out
well it was pointed out to me that the leak must have been at the head, theres blow-out between each cylinder stud and on the head
yes sir I did about 13 riding hours ago before it blew. must have developed it or something :-/
im starting a new thread for my engine rebuild, I finally took it all apart and took the motor out of my blaster, the piston has a nickel sized hole right in the middle of it, the rings and side of piston seem to be in not to bad of shape, the bore is in GREAT condition still, no scratches gouges or anything. it had 150 psi before it blew. im thinking it was a airleak but forgot to leaktest before tear down, after a long hard ride it would rev up at a stop and going slow in 1st gear it would pulsate and drive on its own until I hit brakes. so airleak im guessing. I think I may just throw in a new wiseco piston same size and clean the bottom end and call it good, it has a wiseco crank I found out also I:I , let me know what you think. also all my mods are in my sig. I also had a 350 main, so again, airleak maybe. ps, I found a small crack looking thing at very bottom of sleeve were its paper thin (pictured)
Im not sure that is a wiseco crank heres a pic of my wiesco
