Well i haven't ran it since i found the leak, and don't plan too till i get a leak down tester from Slick.
And really only 10? I thought it was like 3 hours like stated before?
Blaster Fix up!
- Thread starter Longview
- Start date
Well i haven't ran it since i found the leak, and don't plan too till i get a leak down tester from Slick.
And really only 10? I thought it was like 3 hours like stated before?
Well what do you know, I was wrong,
Slick only recommends 5 minutes.
Then way does everyone say hours on end. :-/
From what a hear about double condoms is you better your chances of them not working. 8-|
That makes sense, but 4 hours seems like overkill.
What do you guys use to paint plastics? I'm not sure if i like the Blue. If i can find some nice rates for power-coating i was thinking about a Black And orange theme. Frame being Orange. Any ideas?
there is a creting kind of paint called rino bully or somthing to that effect u can find it at tractor stores it is a special kind of paint that soakes into plastics and u can then spray them with primer.... if u look it up u should find it is something bully "plastic paint adaevise "
I couldn't find anything about that. :-/
You guys think i should clear coat over it, if i plan on doing this?
I was also thinking about moving my key to the side, like where the 03+ models have them, So i can put a bar pad on my bars.
How doable do you guys think that is?
How doable do you guys think that is?
Today my old chain finally slipped off and bunched up in between my sprocket and swing arm, and needless to say it doesn't want to come out! I'll post up a sh*tty cell phone picture.
I need new swing arm bushings, so i'm just going to take the swing arm off and that will release the chain and I'll replace everything.
I'm thinking carrier bearings too.
I don't have all the cash for that right now though. Is it alright if i let it sit for a couple months with fresh oil in it? Maybe run it every now and again.
Similar threads
