Sold one of the blasters today

[Herpderplol]

Ok good. That's cheaper than porting, and I doubt that's a "must have" type thing

 

[DUALSTROKE]

I see your mods. I also see its a KOR cookie cutter motor. Don't start a pissing match on engines. I don't have the time to deal with you.

Maybe my gauge is right and I've never had the misfortune of messing with a stock blaster motor. I'm going by my experience with countless other engines.



But yea,, 115-130 and lower = low.

Well was reading a decent thread till chuckles the clown chimed in.Cookie cutter? Coming from the guy/girl who is asking how much should he take off his cases to fit a 4mil crank in them.Yet you don't have time to start a pissing match on engines that you know everything about.Yet he/her doesn't know how to measure to see how much to take out for a 4mil crank. Guess the snowflake port scared wittle chuckles away!! I will have to request he put a chuckles the clown port template in the next vid he does.I would guess it would look something like a rainbow.I see you are trolling other builders that are proven winners.What cookie cutter trophies,#1 plates etc do you have to show? Im done I have no time to deal with you.

 

[Wifesblaster]

No matter where you go there will always be haters! Do you think all these people would be spending their hard earned money with a builder if the builder wasn't top notch in every aspect of business? I have nothing to gain by promoting KOR. Choose whatever builder you would like. I know that he has built 2 motors for me so far and I'm sure there will be more. I simply share my experience and ride reports on this forum. I am very pleased with costomer service and performance.