so hey guys i thought id make a tutorial out of this since i'm too cheap to buy chain rollers right now and had wheels sitting around.
Anyways first you will need:
skateboard wheel:
bolt, 2 washers, a nut, a lock-nut: (yes it is straight the lenses on my gopro does tht)
drill bit/screw gun:
and a saw-zall/hacksaw (hacksaw for if you have swing-arm removed i don't think it will fit otherwise)
First: remove old roller (if any is left) cut the shaft for the roller off.
^^removed i forgot a before picture
Second: take your drill bit slightly larger than bolt.
Third: slid bolt into hole, and tighten nut on the other side, slid a washer onto bolt then your wheel, washer, and lock-nut.
Fourth: your done congrats on your super cheap and easy chain roller.
Note: i believe now you can run dirt bike chain rollers now as i think the bearings are the same on skate wheels and dirt bike chain rollers.
Note Note: you can also do the same thing to the bottom but the wheel is alittle large so maybe mounting in a bolt sticking it in a drill press and filling it down somehow would make it fit better
This would be a nice sticky if y'all find it helpful.
Anyways first you will need:
skateboard wheel:

bolt, 2 washers, a nut, a lock-nut: (yes it is straight the lenses on my gopro does tht)

drill bit/screw gun:

and a saw-zall/hacksaw (hacksaw for if you have swing-arm removed i don't think it will fit otherwise)
First: remove old roller (if any is left) cut the shaft for the roller off.

^^removed i forgot a before picture
Second: take your drill bit slightly larger than bolt.

Third: slid bolt into hole, and tighten nut on the other side, slid a washer onto bolt then your wheel, washer, and lock-nut.

Fourth: your done congrats on your super cheap and easy chain roller.

Note: i believe now you can run dirt bike chain rollers now as i think the bearings are the same on skate wheels and dirt bike chain rollers.
Note Note: you can also do the same thing to the bottom but the wheel is alittle large so maybe mounting in a bolt sticking it in a drill press and filling it down somehow would make it fit better
This would be a nice sticky if y'all find it helpful.