Rear hubs

[blowncash]

Before I force anything,are the castle nuts that hold the hubs on the rear axle of the Blaster right hand or left hand thread? Thanks

 

[yamaha28]

The axle is just like any normal bolt, lefty loosey, righty tighty. If it isn't going onn very well try running a 14mm dye through it if you have it. Or just clean out the crud with a small screw driver so it goes in easier.

 

[blasterdemon7]

There the normal thread. .

 

[Blaaster]

When you put them back on, nip them up to 87ft lb and use a new cotter pin.

 

[Larry's Shee]

The only left hand thread is inside the flywheel for the PROPER flywheel puller.

 

[blowncash]

Cool! Thanks Guys! I havent done it yet. Im waiting on my new hubs. This is much better then trial n error. I seem to recall the rear axle having some left handed threads near the carrier bearings,but I cant remember what it was I was fixing at the time. Many years ago (projects ago). And then again I could be completely wrong,just a bad dream! LOL One more question before I start a new thread! Im looking at a Raptor 80 for my 7yo daughter. I see these things have 3 lug rear wheels and I think 7" rims. Do any of use guys know if the blasty hubs will bolt onto that 80?

 

[York Racing]

You would have to find out how many splines each axle has. If the number is the same, it'll work.

 

[Blaaster]

You would have to find out how many splines each axle has. If the number is the same, it'll work.

Not so, if the axle is a different diameter it is not going to fit even though it has the same number of splines.