New to 2 strokes.

[joeak47]

Shindy carb kits are made in JAPAN.

Ive tried all the carb kits out there over the years and have had no issues.

Maybe its you? What do you not like about them?

Enlighten me.

 

[82cutty]

Good to know...I still wouldn't use them . I like genuine carb parts .

 

[dirtysquared]

View attachment 26806 View attachment 26806

I'll second Joe on that being a Stock Mikuni 26mm Carb. Like he said, Keep it, they are very easy to use and tune.

 

[joeak47]

Good to know...I still wouldn't use them . I like genuine carb parts .

K&L carb kits are made in JAPAN...
Where the hell do you think mikuni carb kits are made?
I'll give you a hint... JAPAN

 

[82cutty]

There's nothing wrong with me . You can use whatever you want . I just like the genuine carb parts . And no $hit Mikuni is Japan . Thanks for letting me know

 

[joeak47]

Throttle back man ...Easy...Easy.
I hear ya.
You only use GENUINE mikuni kits... (that are made in Japan)... the good stuff. Uhhh ok.

 

[Fast6hand]

I use the shindy kits as well. They are great!

 

[Oneshot]

Fixed the leak, did oil block off. Changed all the seals I could access while I was there.Tomorrow I need to readjust floats, do rear brakes,drain fuel tank,hook exhaust back up.adjust air/fuel screw then hopefully a plug chop.

 

[joeak47]

Sounds like you covered just about everything.
It'll be fine.

 

[Oneshot]

Pulled the slide in carb apart to check needle setting. And dod not look before I did this.There is 3 holes in the slide.2 for the screws and then another. When I look at it from the bottom should I be able to see through that hole or should the throttle plate have that hole blocked?

 

[Oneshot]

See how you can see light through the hole? Is that correct or should I take it off and spin the throttle connection around?