new 11 rims n hubs but bolt striped
- Thread starter x-man
- Start date
thats kinda what i thought it would be but im dealing with a rim with hubs on them n one of the bots is stiped n they are really deep rims n i dont have a air or impact gun so im going to have to get a bigger extension but mainly the issue is the stiped bolt
i
im not really sure how to post a pic of them on here but basically iv got a rim with a tire on it an the rims have hubs on them so literally tire rim hub sitting there and no axle to hole the rim in place so ya
Best I can suggest is you have to get in there and grind the nut off. Unless you could get in there with a nut splitter.
Well, then hope they were cheap or looks aren't most important thing. IF you use care ............
Umm, aren't the splines slightly tapered ?. Plus, isn't any more room on one side than the other. JMO.
I'm not sure if they are or not but I didn't think they were.
I suggested that because by cutting the nut off you're likely going to dig into and knick the rim. Grinding the head off the stud on the back of the hub means you won't be touching the rim, just the hub. That's why I suggested it as he seems to want the rims, not the hubs.
Anyway, if they're tapered they may not work. I was just throwing it out there.
Ok I jut skimmed through this quick. So you have a stripped nut on the wheel stud? Irwin and craftsman both make sockets for stripped nuts. I'll try to find the link.
Ok I found a link. I hope it's what you need. http://www.ebay.com/itm/like/111915...7290-0%26rvr_id%3D1039173403780&ul_noapp=true
Ok I found a link. I hope it's what you need. http://www.ebay.com/itm/like/111915...7290-0%26rvr_id%3D1039173403780&ul_noapp=true
Last edited:
Similar threads
