Clear clutch cover
- Thread starter mervhengst
- Start date
thanks blaster. I just got it changed out with the cover that was on and found out that the old one was JB welded and it was done horribly wrong. Glad I caught it now.
I used lexan on it. I have 3 4ftx4ft sheets plus a couple of smaller sheets that I have no use for so I used it to make that.
I don't believe it will. its pretty strong stuff. as soon as I get oil in it I will run it and let you know what happens if anything
ok BF....I ran it through a heat cycle. lexan held up find. it didn't melt or distort. I do have a slight leak but it didn't even drip through out the night. so its a very slight leak. still going to take it back of and do some slight mods to help seal it better.
Been a month since I put the clear cover on and so far so good. Had it out riding pretty hard about 10 times and its still holding up fine. Had a leak but I figured out that my screws weren't tight enough. Tightened them up and so far no leaks.
i still gotta get that clutch cover off my spare bottom end and get it sent out to ya.
i got really busy with work these last few weeks, but slowing down now....right in time for archery season
gonna try to get to it this week
i got really busy with work these last few weeks, but slowing down now....right in time for archery season
gonna try to get to it this week
just let me know Awk. Im in the middle of moving so I will have to get you my new address. Good thing is I will finally have a garage to work in.
lemme know when you get all moved, no sense to drag more stuff around....moving sucks as it is X(
