Carb mounting and cable questions

[jjj_85]

I have a 35mm sudco racing carb I want to put on my blaster. Its a mikuni flatslide. I dremeled out the intake and it fits on that no problem. The carb bowl hits the clutch linkage though. I was wondering if a reed spacer would help this? What can I run for a cable? I dont think there is any way the stock on will work. Thanks

 

[brandoz28]

not sure on the cable, but the reed spacer should work

 

[super noober]

you need a cable made to fit that carb, i know for keihins, motion pro makes one the correct length for a blaster.

 

[Brainmatter]

With the spacer you'll be golden! It actually gives it more room than you'd think it would by looking at it.

 

[jjj_85]

Good I got a spacer comming then. Now about the cable. Where do I go abouts finding one then? I think it just needs a open end like a clutch cable on the carb end, but I dont think something like that would work on the thumb throttle end....