OK here is the deal, I bought a used crank case off eBay n I am trying to replace the left side balancer shaft bearing and I can't get it out. I have put heat to the case around it n grabbed the inner part with players and tryed to lightly tap/pull it out but its not budging. Any tips to help with this? Thanks
balancer shaft bearing
- Thread starter Arnold
- Start date
oconnor would be the man with a plan for your exact problem my friend his work # is 1-860-230-5003 he always answers hell or high-water anytime after 10 in the morning and extreamly knowledagable
you will need a blind side bearing puller to get that bearing out, it basically expands and grips the inner race then you attach a slide hammer and pull it out, there should be a puller set on ebay if you look, always a useful tool to have.
This one is the cheapest i could find in a hurry : http://www.ebay.com/itm/BLIND-HOLE-..._Automotive_Tools&hash=item5d3bc759fc&vxp=mtr
This one is the cheapest i could find in a hurry : http://www.ebay.com/itm/BLIND-HOLE-..._Automotive_Tools&hash=item5d3bc759fc&vxp=mtr
Last edited by a moderator:
Blind bearing puller is the way to go if you have one. You can also toss the case into a toaster oven @325 for about 15 minutes. Take the case out and smack it a couple of times on a soft bench (wood). It should fall right out.
Well I tried the oven trick n no luck looks like I'll have to bring it to a local shop to see if they can do it
