yb200's build....

[Awk08]

hows the temp in the garage??? keep and eye on the jetting (no not the mains, the other circuts) if your in the cold, give that plug a look, make sure ya aint runnin all that high priced, dyno chart stuff lean, even at idle and 1/4 throttle, or at least make sure that pipe stays smokin

 

[yb200]

i only blow air when needed

 

[blaster01]

nice vids man.....lookin good

 

[yb200]

 

[blaster01]

are u gonna run ur spacers are did u ever use those, i cant remember

 

[yb200]

i sold the spacers because when i turned my tires hit the nerfs

 

[kx80berger]

i cant wait to get mine done

 

[yb200]

hows the temp in the garage??? keep and eye on the jetting (no not the mains, the other circuts) if your in the cold, give that plug a look, make sure ya aint runnin all that high priced, dyno chart stuff lean, even at idle and 1/4 throttle, or at least make sure that pipe stays smokin

i got it at about 60-65 in the garage....did 2 heat cycles smoked the sh*t outta the shop lol.....ill prolly mess with the jetting come spring when it gets warmer out....

 

[AT Blaster]

Sexy bike.... And it sounds good?

VERY NICE!

 

[mr_3_0_5]

sounds nice man.. bet you just wanna hop on it and take it for a rip..

 

[UniRacing]

sounds nice man.. bet you just wanna hop on it and take it for a rip..

Yes i do!!

And i would if i lived close to YB...

 

[yb200]

got started on my see thru stator cover when this is done the clutch cover will be next

 

[blaster01]

did freek like give u his "Blue prints" on how to make these or are u just kinda winging it and hopeing it comes out good?....doesnt seem like it would be to hard though

 

[yb200]

did freek like give u his "Blue prints" on how to make these or are u just kinda winging it and hopeing it comes out good?....doesnt seem like it would be to hard though

freek hasnt helped me at all...its not that hard to cut out a circle and bolt on some plexi and aluminum

 

[sc0r1a]

did you get my stuff i sent?

 

[yb200]

yep those are the ones i am working on


here is the clutch cover ruff cut.....i need to smooth and round the edges better with a file

 

[UniRacing]

nice how you plan on sealing the plexi?

 

[yb200]

gasket maker or three bond

 

[stephen12091985]

gonna make any designs in the plexy?

 

[yb200]

maybe...................................