throttle cable problem

[2smoker85]

i just moved my clip up on my needle, reinstalled the tors, and now i have no thumb throttle response? not sure but i pulled the tors back out and it was hooked up right, the throttle cable is in the brass lever from the thumb throttle, but when i put it back together and push the throttle it doesn't move the lever like it is suppose to, if it is the slide stuck, how would i go about fixing it?

 

[245stroker]

You may have to turn your slide 180 degree's. Pull the carb out of the boots and make sure the slide is almost all the way closed.

 

[2smoker85]

if its not closed can i do it by hand without hurting it, i mean i don't want to break it.....that would suck!

 

[98blaster+4]

if its a stock carb ,there is a slot that needs to be lined up or its not goin anywheres, and if the slide is damagaed you may need a new one

 

[2smoker85]

if its a stock carb ,there is a slot that needs to be lined up or its not goin anywheres, and if the slide is damagaed you may need a new one

slide is undamaged, and the needle is in the hole it is suppose to go in, but when i put tors back on the carb, it acts like it is stuck, it pushes the lever back up and the throttle cable becomes loose with no thumb throttle response.

 

[98blaster+4]

do you have the slot on the slide lined up with the nub inside of the slide bore?

 

[2smoker85]

not all that familiar with what you just said, where can i check this? not a carb guru give me some step by step stuff to try and i will do it tomorrow, might have to be thorough so i can decipher it and get my quad to run so i can go play in the snow!

 

[Unstock240]

He is talking about this slot in the center of the guys index finger. tab or pin on the carb aligns in that. Could be a spring in the tors or the actual throttle in a bind.

 

[mr_3_0_5]

yep unstock is right.. the slide has a groove and the inside of the carb has a pin just line them up make sure you need drops throught and screw the cap on should be good to go..

 

[2smoker85]

will give it a shot, then i will let you know, thanks guys, been trying to get this blaster in the snow and see how much of a difference these upgrades made

 

[blasterboy91]

you may have your cable pinched...if not then im out of ideas...everyone else hit the nail on the head