Start it then dies

[jtblaster]

Actually my mistake, i cleaned it out first time, not the others, totally forgot. It probably needs it cause after first clean the second time carb was a tad dirty. Ill try that first.

 

[jtblaster]

Actually my mistake, i cleaned it out first time, not the others, totally forgot. It probably needs it cause after first clean the second time carb was a tad dirty. Ill try that first.

 

[Blaaster]

It may pay to check the tank for cleanness, there should not have to be a second cleaning of the carb if it was cleaned properly first time.

 

[jtblaster]

Okay i figured it out...the cable on top of the carb cap needed adjusted. New problem though....slide in carb sticks. What could this be?

 

[Herpderplol]

Is the spring inside the carb?

If not thats the problem.

If it is, is the slide on the locating pin?

 

[jtblaster]

Is the spring inside the carb?

If not thats the problem.

If it is, is the slide on the locating pin?

Yes spring is in. And what is the locating pin?

 

[Herpderplol]

There is a little pin sticking into where the slide goes. And the slide must line up with it to be put on. If not lined up, damage to the slide will be there

 

[Blaaster]

Okay i figured it out...the cable on top of the carb cap needed adjusted. New problem though....slide in carb sticks. What could this be?

You may have a sticky cable, do not use WD40 to lubricate.

The slide has a slot on one side which slips down over the locating pin found halfway down the tunnel.
If the pin is damaged the slide may bind.

Make sure there are no snags along the slot in the slide.

Use no oil on the slide and it must be spotlessly clean to work properly.