I would like to upgrade the factory sprokets for a little more top end, what is the best way to go on a stock blaster
sprokets
- Thread starter jason86
- Start date
depending on how much more top end you want, id go with a smaller back like 38 or 37 or a bigger front(14) one tooth on the front= 3 teeth on the back
14/40 or 14/39 with a bone stock blaster. You don't want to gear it to much for top end or you wont have any bottom end left.
right now not much at all, I've only had it about a month. It has pro circut silencer, everything else was just eliminating useless sh*t. I'm planing on getting full toomey or LRD exhaust, reeds and cage, aftermarket carb and i'll prolly bore it .50 or .60 when rebuild comes about. any opions will be greatly appreciated
i'd say with that, use a 14/39 or 14/40 ... 14/40 will give you a litttle more bottom end than the 14/39 ... 14/39 is going to give you more topend without losing much bottom end, but either one will give you more top end (i vote 14/39)
true.. so go to a 14/39 then... 14/40 is pretty good but, if you think stock is wayyy to low, go to a 14/39
will my chain work with that combination?? because i found the sprokets and chain for like $60 but wasn't for sure if i would need a new chain
you dont necessarily need a new chain unless yours is bad, you might have to take a link or 2 out tho
Similar threads
