Seat Cover Installation

heyketz

New Member
Jan 18, 2011
476
2
18
Just got a seat cover from eBay. Going to use an electric staple gun with 1/4inch staples and some spray adhesive. Anyone have any tips or tricks on how to install?
 
i put my new seat cover on 3 weeks ago, stretch it down towards the plastic, staple the front once or twice, then go on each side back and fourth until you reach the back, i left mine to have a little slack so its not super tight so it doesnt rip
 
Thanks chevymuddman --- you must of had some hands on experience with that - VERY important - tip #1
 
Just picked mine up from the upholstery shop yesterday. Best $25 I have spent for a long time. I tried to put it on when I first got it. I could not get it to fit well in the front where it levels off frm the tank.
 
Just finished putting on my new seat cover. Came out pretty good. (for a rookie)
1989blasterseat3.jpg

1989blasterseat2.jpg

1989blasterseat1.jpg
 
same job i did, but left just a bit more slack cause i put my knee on the right middle of the seat when doin wheelies, ripped the stock cover, so i left alil more slack and now it should hold up forever!!
 
Lots of color combinations to choose from. Fits good. The material seems to be pretty durable and double stitched at the seams. $23.99 +$7.99 priority shipping = $31.98 delivered to my door.
 
Looks good man. Wish I could have got mine to look that nice but it was worth paying someone else to do it so that it does look good.