seals again wtf some one help

[06blasterboy06]

i just replace the seal near the sprocket but oil still comin out what do i do help help help please im so pissed i dump to much money in this quad to let it goI:I

 

[Oregondunes]

output shaft bearing is wore out. replace it this time when you do the seal again.

 

[sicivicdude]

check the vent line coming off the top of the transmission!

You've said three different transmission seals are leaking now. Not a coincidence. If the vent line is blocked up, the pressure generated by heat inside the transmission has nowhere to go so it blows out seals.

 

[sheeblast]

i say check the shaft to make sure it isn't pitted or anything.

 

[YFS101]

+3 or 4

these guys are right, if they keep going something else is causing the problem. either bad bearing, worn/grooved shaft, or plugged up vent line.

 

[06blasterboy06]

wht it is when i put in on around the sprocket shaft the lip was coin out i dont if it was bc the sprocket screws are to long because they do hit the seal ant i dont now where the vent line is at can some hook me wit a pic

 

[YFS101]

if the screws are hitting the seal get shorter ones.. when you install the new seals you should grease it up and also tape over the plines on the shaft so it does not damage the seal

 

[06blasterboy06]

yea it was the f ing screws lol but i got that b 4 u said but man those seals are like 8 bucks man but thank u guys man