Rolling again! updated pics

[Larry's Shee]

I always confuse caster and camber. Caster is the lean of the spindle front/back correct? If it is, I kinda thought about that, maybe incorperating some machine bushings (precision flat washers) between top arm and mount front and back. Thought with two in front, two in back, would give 5 possible combos.

I swear sooner or later I will do this. Surprized no one else has done this that I'm aware of , you get better suspension, hydro brakes, for the price of extended arms. I:I

Also, do you know what years yfz are same? I know your measurements won't work with "X" or "R" pieces.

Was the +2 arms even better ride? Any problems on trails with wider width?

 

[Blaner]

yes Larry, caster is the angle of the spindle. I know Houser uses sets of washres you can juggle around to set a number of caster angles. My setup uses the heim joints, which give more adjustability, but shims are much easier to change out etc.

In terms of ride, the shocks are obviously a bit softer, which is nice, I havent had a problem with the extra width yet, I quite like it, immensely stable and well footed. I would not go any wider however.

 

[Larry's Shee]

Ya plus 2 puts it right around 48", which is about 6" more than stock. Glad to see you around, hope live is treating you well.