quick question regarding jetting

[troyzstang]

Another question about jetting

*stock carb
*fmf fatty
*boyesen reeds
*no lid
Currently running
32.5 pilot
360 main
I don't have any history on this bikes performance. Just looking for input from the Pros.
Any suggestions Gents
Thanks
Troy

 

[Blaaster]

#360 main seems pretty rich.

At sea level #270-#280, stock needle on middle clip, should be better, but only plug chops will tell.

If it seems to be running well with the #360 Iwould be looking for an air leak somewhere, do a leak down test.

 

[Blaner]

wow 360 is huge. you most likely have an airleak with that, id suggust a leak test be done ASAP!

i ran a 330 with a FMF, serious prt job, boyeson reeds no lid blah blah blah and it was happy. i also had the banshee needle tho.

 

[Surfrjag]

are you sure its not a 260? have you got it running already? i would say a 290 is what you would want because thats what i had in the exact same setup.

 

[troyzstang]

Ya she's running. Just have to adjust the clutch again
I'll check the main to be sure.

 

[vspec]

damn that's one clean blaster.

 

[Larry's Shee]

How's it running? What does plug look like? What is your question?

 

[troyzstang]

Just had her out. I got the clutch adjusted. I can't believe the covers not leaking
i've had that damn cover off at least 3 time for different issues. ( I'm a dumbass)
Anyway seems to run strong. No boggs or hesitation throughout the rpm range. So I must have read the numbers wrong on the main jet. Damn I'm getting old
Here's the before pics.

 

[Blaaster]

To be sure, to be sure, do a plug chop!