quadboss cdi

[lofosho97]

Just purchased a quadboss cdi for my 06. The directions were very vague and im not sure if I understand them. Wish now I would have just got an oem one but its here and I really want to here this blaster run again. It says:

black/red-power coil (im assuming this is power to the ign coil)
black/white-killer (killswitch wire?)
orange-ignition coil (directly to coil)
black - ground (ground to chassis or is there a ground in the cdi harness)
white/red-sensor ground (clueless)

any help? Had plans to ride with some friends in the morning if I can get this going and dont wanna miss out.Thanks.

 

[Awk08]

the complete wiring diagram is available here.........


http://www.blasterforum.com/general-support-17/downloadable-yamaha-blaster-manual-17325/

 

[scotj77]

the wires are all color coded to match up with the stator. it should just plug right up by matching up the colors

 

[lofosho97]

well the quadboss cdi has 5 wires coming out of it with bullet style terminals on the end of the wires. And of course the blaster has an oem plug. Do I cut the wires at the plug? What about the tors? What is the sensor ground they speak of? What sensor? Does this thing modify the oem cdi or replace it all together?

 

[Awk08]

i'd say if it doesn't have matching ends for plug and play, it is not for a blaster

 

[lofosho97]

I ordered it from bikebandit. I normally get parts from rockymountain but they didnt have one. I initially thought the exact same thing so I called and they assured me that it was. It even says blaster on it.