Need a little advice

[FordMan7072]

I'm need some advice with my blaster. The motors supposedly about 20hrs on it and built with a bbk weisco pistion,stroker crank,34mm flatslide,v force 3,fmf sst and a uni pod on the back of the Carb mixed at 32:1 When I first got the blaster it rattled a little bit every blaster I've had or ridden had a little rattle but I went out riding probably an hour or so didn't ride really hard just Rodriguez fast and did some hill climbs. But a few days later I fired it up and it seemed to rattle louder but has no loss of power and still fired within 2 kicks cold. I did a compression check and its 120. Should I be getting propared for a top end? I just don't want it to blo.w and have to crack the cases. Any help.

 

[blasterBruce]

Have you done a leak down test , plug chop , or pull carb and check the jetting ?

 

[FordMan7072]

I have done a plug chop and it was a OK. I just pulled the exhaust and looked at the pistion and it looked almost new with just a few scratches but I could wiggle it a little with my finger.

 

[Awk08]

I have done a plug chop and it was a OK. I just pulled the exhaust and looked at the pistion and it looked almost new with just a few scratches but I could wiggle it a little with my finger.

that all sounds just fine,
i'd be pulling the side covers to check for possible loose parts in the flywheel and clutch areas.
kudos for not running it to death and asking for help before it implodes.
keep us posted what ya find