Hey guys,
Today I am finally buttoning things up on my rear end rebuild. I have a round housing rear bearing from LSR and the stock rear hub. I did the correct procedure for tightening the stock axle nuts but the hub seems to be rubbing on the bearing seal of the housing. its not bad and the quad rolls but i can hear it squeaking. I just don't want to wear out that seal. IS this normal did I do something wrong or am I missing a protective cover or something? I also could only back the inner nut off to about 140 ft/lbs not the recommended 170. there is no play in the hub. HELP! I DONT WANT TO DESTROY MY BRAND NEW HOUSING SEALS!
Today I am finally buttoning things up on my rear end rebuild. I have a round housing rear bearing from LSR and the stock rear hub. I did the correct procedure for tightening the stock axle nuts but the hub seems to be rubbing on the bearing seal of the housing. its not bad and the quad rolls but i can hear it squeaking. I just don't want to wear out that seal. IS this normal did I do something wrong or am I missing a protective cover or something? I also could only back the inner nut off to about 140 ft/lbs not the recommended 170. there is no play in the hub. HELP! I DONT WANT TO DESTROY MY BRAND NEW HOUSING SEALS!