Little spark/ wiring help
- Thread starter Shane1013
- Start date
Crank seal is leaking. Buy a flywheel puller and remove it. Then do another test to verify its the seal.
The Napa near me does but not in stock you have to order. Might as well get one from eBay or Rocky Mountain ATV. If you have a Motorsports store near you they most likely do just make sure it's the correct size.
Starting fluid ( which I may add should never be used to attempt to start a 2 stroke ) will start engines wit many serious problems.
If there is adequate compression, the carb is clean, the float level correct, the air screw at 1 1/2 turns out, and you have good spark on a new spark plug the engine should start easily.
I am curious on how you worked the flywheel off, it must have been on pretty loose.
If there is adequate compression, the carb is clean, the float level correct, the air screw at 1 1/2 turns out, and you have good spark on a new spark plug the engine should start easily.
I am curious on how you worked the flywheel off, it must have been on pretty loose.
Yes there is enough compression..and for the float level how do I set that?.and yes I have the air screw 1 full turn n a half turn out..n yes the flywheel was loose when it came off the first time now it won't come off at all w.o the puller..will a stripped key affect it from starting ?
Ya think maybe this is why it won't start? Sucking air in through the bad crank seal and not through the carb.
