ik its been covered here before, but can someone explain to me in detail how to do plug chops for the low mid and WOT?
help with plug chops
- Thread starter mitchellrj1988
- Start date
omg really?
to do a plug chop you do that following
1) warm quad up with old plug
2) once warm you put new plug in
3) take quad down rode and shift through the gear, once in 6th, you hold the throttle at what ever position you are checking for jetting
5) hold throttle at position for about 15 seconds
6) after 15 seconds turn quad off and coast to a stop
7) put old plug back into quad and ride home
to do a plug chop you do that following
1) warm quad up with old plug
2) once warm you put new plug in
3) take quad down rode and shift through the gear, once in 6th, you hold the throttle at what ever position you are checking for jetting
5) hold throttle at position for about 15 seconds
6) after 15 seconds turn quad off and coast to a stop
7) put old plug back into quad and ride home
i have done everything. i removed the tors, changed my jets from 260 to 320, rebuilt my carb, bought new reeds, changed all my gaskets, played with my mix from 32:1 to 50:1, cleaned and bought a new air filter... and after third it bogs at wot. i cant figure it out. if i give it gas slowly, i can get up in speed, but once i do get there it just bogs. cant figure it out
you can cutt all the way along the bottom, or u can cut down, not hitting core, then cut across
is it still pretty accurate if i just look at the coloration of the plug instead of actually chopping it after i do the test?
A flashlight and magnifying glass work fine. I've never actually cut a plug. What a pain in the ass that would be.
i like cuting it better it takes like 5 mins to do it and i think its alot easier to read
