Front and rear hydro brake help

[bellaemma]

I have a 98 blaster wanting to do hydro brake setup of front and back. What is the best way i should go about doing these. What is the cheapest way and what is the best way? Also some help locating these would be great. thanks

 

[Surfrjag]

easiest way would be find the setup from a 03+ and if you get a good deal on it then it could be cheaper too!

 

[cole454]

^^^+1

If you can't that you would need:
A set of norman420 conversion spindles
A front brake setup from an YFZ, Raptor, Banshee, or Warrior
Front hubs and rotors from any of the quads above

For the back just pm awk08 here for one of his gsxr rear bolt-on setups. Or if you can do some fabbing you can make some brackets to fit a setup from many other quads

 

[3 Wh33l3r Rid3r]

^^^+1

If you can't that you would need:
A set of norman420 conversion spindles
A front brake setup from an YFZ, Raptor, Banshee, or Warrior
Front hubs and rotors from any of the quads above

For the back just pm awk08 here for one of his gsxr rear bolt-on setups. Or if you can do some fabbing you can make some brackets to fit a setup from many other quads

Yfz hubs don't fit on norms spindles without building some spacers. The yfz spindle is shorter than norms spindles therefore the inside of the hub is shorter and require spacers on the inside and outside to fit. The calipers will fit from a yfz on norms spindles, I never tried to swap any of the rotors.

 

[cole454]

Thanks for the info on the YFZ hubs. I knew I had seen a few people use YFZ hubs, just assumed they were bolt-on.

 

[bellaemma]

thanks gsxr setups from awk08 look nice good deal!!!!