well, guy's i tryed pics a million times and myinternet is just too slow but i will put a step by step walk through,
1.get all you tools together, you will need a drill, a large drill bit and a hole saw head, you will aslo need a 10mm wrench for the taillight bolts and a grinder and some silicone, and a pencil.
2. first you should dissasemble the tailight and take the stock mounting bracket and roughly sketch the hole on it.
3 next you should take the large drill bit and drill the bolt/rubber mounting thingy holes, if the rubber things don't fit then reen the ole out a little, repeat on the other hole and make sure its level and the bolts on the tailight match up with the holes.
4. you should now take the hole cutter of the appropriate size and drilla hole a bout 5/8 inches down from the other holes, make sure you leave room for the wires (thelittle wall of plastic iside the box will be in the way so me and my dad just cut it off) . me and my dad drill a larger hole and put it further down, then reemed the top out because it fit better that way.
5. we inserted the rubber mounts( they are a two peice part, leave the ring shape rubber thing out), then put the taillight beack on, and bolted it up
6. i cut the zip tie holding the wires and pulled them into the box, and plugged them into there matching wires, put a thick bead of silicone around the hole and tada, you have a stylich out of the way tailight.
please note that i did this on a 04 blaster, some of these steps might not apply or work for the older 89-02 models.
