You need to buy or make a case splitting tool to remove/replace the crankshaft.
http://www.blasterforum.com/do-yourself-20/diy-crank-puller-43994/
http://www.blasterforum.com/do-yourself-20/diy-crank-puller-43994/
Last edited:
The previous seizure was due to over heatin an possibly a lack of oil-was at the beginning when I first got the bike-was flat out on it for few hours with little breaks-was a total noob then but still learnin an lovin it-jus not the cost so gonna try do everything write-I only dipped the end of the kitchen paper in to see the colour-still a wee pool down there-my con rod has about 1mm play side to side but no up and down play...still contemplating the bottom rebuild or building the top end back up now it's all clean an fully sealed with new air filter on route and fresh plugs to do a few chops-I still need to do a leak test but will have to make one on modify one o can get of a mechanic