i'v done a couple but never seem to go quite the same, my 2000 was rediculous but i had a 96 that every thing but fell apart..... get a big rubber/plastic type mallet or use a piece of wood, the main thing to worrie about is not messin up the threads on the axle,, I also cover every thing in liquid wrend and tap on em to make sure it gets in the cracks with a lil hammer,, there is supposed to be an actuall puller although i never seen any one with one,,, the other thing in my opinion is bearings and seals will cost like 50-60 bucks, every ones budget is different but for 130-140 you can get a rad dual row carrier off e-bay and they are supposed to be much stronger, this also allows you to kinda ,no holds bar'd your carrier housing, if you do this... just set the right side of the axle on a block of wood lube that puppie up and pound him off. the rads come ready to go, just slide axle in..