88 blaster will fire up when pulled but wont stay running

[muddiger94]

I have a 88 blaster it will run for alittle while when pull started if you keep the tjeottle wide open but the second you move the theottle it cuts off any suggestions

 

[Wifesblaster]

Anytime you have a problem the first things you should do is perform these tests and inspection. Leakdown test, compression test, check jetting and clean carb, do a plug shop, and inspect reeds. I know it seems like a lot, but it's not. It will save you a LOT of money in the long run.

 

[blasterdemon7]

First do a compression test. If that's good, do a real good carb cleaning and check reeds .

 

[bigwill]

The first problem is that your pull starting a blaster????

 

[rideyamaha09]

If it sounds abnormal, like its bogging and hollow sounding there is a good chance it is the reeds. Thatd cause it to only stay running when it was held at wide open.

 

[Wifesblaster]

What mods do you have? Do you still have the TORS hooked up?