240 blaster help

[foxracin47x]

ight as some of you may know i bought a race blaster at a rebuild stage all in pieces form a bu8ddy that lost intrest...its all together (runs) but have soime issues....it has a 240 kit (stock carb) ehh =/ its jetted right and i do know aftermarket carbs can slightly add hp.....alright well i got good topend on it...i hand checked compressionw ith kickstart lever in sh*t but like 3rd gear when i reach higher rpms its got like no balls it loses power basically....so no bottom end you could say...would this just be rings? or.....? anyt help appreciated --thanks

 

[chriscblaster]

id plug chop to be sure, im running the same setup. it did similar when the reeds were going, so check them also. and just to be sure change the plug. and check all your electrix. and if all that fails change the needle setting on carb. then try the rings

hope that helps

 

[foxracin47x]

well what wires could cause something like this because i had to buy a harness the other one was lost.....i got alot of unused wires in harness no headlight,no voltage regulator,no tors,no taillight,no oil injection,no key.i have a killswitch unsure at this point what wires attatch to killswitch...

 

[chriscblaster]

ok so its not electrical....ehm, have you checked the rest?

 

[L.T.]

How dose the bike Idle very low, very high, not at all ? What sprockets do you have on there.

PS Mix 2stroke withe petrol not Petrol with 2stroke LOL Just a joke...