2000 blaster need help!

[Fox121]

My 2000 blaster idles but as soon as i touch the throttle it boggs out and if i hold it too long i dies i release it idles like normal. what might this be.

 

[brandoz28]

could be the tors acting up


search for how to remove it

 

[B_Rad_NC]

Check out the tors, and pull your carb and take a look at your reeds. Mine did this when i had a broken reed valve.

 

[Scrappy]

Sounds like reeds to me also.

 

[gsugarek]

Sounds like an easy fix. Clean your carb, clean your reeds, and clean your airfilter. I would just clean everything first, could be like others said a broken reed, but hopefully not.

 

[royalt67]

My vote is on the TORS.

 

[Drifz1]

sounds to me the choke is stuck! if not jus clean the carb"!"

 

[Blaner]

i vote for reeds

 

[20blaster02]

Sounds like a stuck choke, or reeds. But like mentioned earlier, i would check and clean the Carb, Air Filter, and Reeds. If none of that is the problem, then i would look at the TORS. I removed mine and have never had a fuel/oil/bogging problem since. Its very easy to do..

 

[Fox121]

okay still havent figured out what the problem is i cleaned the carb thoroughly and cleaned the pipe and replaced a crank ceal and it is still doing this should i look at the tors next

 

[xJust_Causex]

TORS would have been the very first thing I woulda tried and probably could have saved you a lot of work. Then if that did not work then I would have delved into cleaning the carb.

 

[ybeckes]

can someone please explain to me what the tors is....i was having the same problem with my laster and i called a local shop and they told me that the parking break sensor was sticking.....they told me to take the front hood plastic off and disconect a conector consisting of a black a yellow and black and a yellow wire....i did this and it took care of the problem

 

[hawk]

TORS is Throttle Over Ride Sensor I believe. It only takes about 5 minutes to remove it for good. But ya, it sounds like TORS or Parking Brake sensor.