yamaha blaster 35mm mikuni jetting

[bcolella4]

sorry yet another post just found this carb that im gunna order. here is the link Yamaha Blaster 35mm Mikuni Big Bore Carb | eBay

but i was wondering the jetting for it. i have kor port and polish k&n strait filter timing advance, head mod by kor ,power reeds i live in nj. i also have an fmf full pipe with it bored .40 over. thanks for the help again guys i will be running a modded intake boot that will be stretched

 

[Blaaster]

Be very wary of stretching the carby boot if it is a 26mm one.

What other mods do you have, air box lid on or off, what pre mix, what elevation, temperature?

Running a larger bore carby with a FMF pipe, will nullify the low/mid power that the pipe is designed for.

I

 

[bcolella4]

strait airfilter not sure of elevation, yamaha 2r, like 80 degrees and the fmf isnt good for abigger carb?

 

[Blaaster]

Larger carbys are usually recommended for BBK, ported, and pipes favouring the mid/top range, and the use of exotic fuels.

I would be very much surprised if you gained much by running a large carby with the FMF and your mods.

 

[Herpderplol]

I wouldnt be surprised if you lost some by do that big of a carb....

Gaining will be more of a surprise

 

[Blaaster]

I have a Mikuni 35 TDXX D slide carby sitting on the shelf, just waiting for the right motor/pipe combination to slip it on.

 

[bcolella4]

what would u guys recommend for my motor with the porting and head mod and everything
and what jetting u thinking around i live in jersey