varying idle

[Busted Warrior]

I took the tors of my blaster and have the regular throttle cable and cap on my carb. But since then the idle is off. It seems like the cable is too short and pulling the slide in the carb. I tried re routing it but it hasnt helped. If anybody has a pic of how they ran their throttle cable with tors removed that would be great!
Thanks
Justin

 

[quam]

did you try adjusting the idle control knob under the seat?

 

[quam]

or try adjusting the cable itself to give it more play?

 

[stephen12091985]

if the tors if off there is no idle control under the seat.

 

[Mr.Trans-Am]

what is tors? im new i was jw

 

[joedirt5724]

t.o.r.s Throttle Over Ride System , its a safety sensor in case the throttle sticks. if u have a stock carb setup, its the big bulky thing what the cap that the carb is attached to.

 

[quam]

if the tors if off there is no idle control under the seat.

depends on how he did it.
i have an '06 and i just clipped the wires and left the carb alone.

 

[peacher213]

Sorry Its kinda hard to get pics, Its chilly and rainy outside

 

[kylepotatoes]

Try adjusting the cable at the top where it goes into the throttle, screwing it in will lower the idle and screwing it out will raise it.
And on page 34 of this http://www.rydindirty.com/blastermanual.pdf is how to route your cables.