i am planing on unhooking my Tors 2day and was wondering do you still use the screw under the seat to adjust the idle or what???
tors idle
- Thread starter redbabeboy
- Start date
nope, you will need to get a screw to on the side of the carb, i have seen them on ebay and some tors removal kits.
sporty
sporty
yea that's what i was going do,but my question is after i disconnect the wires lets say later on i wont to adjust the idle do i just turn the screw,or will i have to reconnect the tors wires or what?
This may help.
Idle adjusting.
Start with air screw 1.5 turns out.
Set idle screw so that it has some sort of idle.
Warm up motor and then set idle screw for a fast idle.
Adjust air screw either way to get the fastest idle.
Adjust air screw a little at a time leaving 10 secs to allow the motor to respond.
Re adjust idle screw for desired idle .
Idle adjusting.
Start with air screw 1.5 turns out.
Set idle screw so that it has some sort of idle.
Warm up motor and then set idle screw for a fast idle.
Adjust air screw either way to get the fastest idle.
Adjust air screw a little at a time leaving 10 secs to allow the motor to respond.
Re adjust idle screw for desired idle .
thanks was wondering this my self i did the tors delete and it has never idled since
