stator?

Did you replace the stator plate with both coils, or just a single coil.

Sounds silly I know, but folks have replaced the wrong coil.

Did you try a new plug, even though some plugs will allow idle conditions they can break down internally when given throttle.

Have you tried trimming a little off the end of the HT lead at the plug cap end?
 
Last edited:
i just said that cuz you said that it would not start i was under the impression that it just kills it from revving but not starting....anyone??:)
 
Did you replace the stator plate with both coils, or just a single coil.

Sounds silly I know, but folks have replaced the wrong coil.

Did you try a new plug, even though some plugs will allow idle conditions they can break down internally when given throttle.

Have you tried trimming a little off the end of the HT lead at the plug cap end?

Idk it has two coils I bought a whole new one...and ive tryed that...and how to do that??
 
Remove the plug cap and trim a little off the spark plug lead, replace cap.

Carb cleaner, but just soaking is not good enough one has to dismantle and clean paying attention to passages and jets.
 
Remove the plug cap and trim a little off the spark plug lead, replace cap.

Carb cleaner, but just soaking is not good enough one has to dismantle and clean paying attention to passages and jets.

Well I think my other plug was good so..and okay..any other opinions on how to make it rev??
 
it started but wont rev and the tors was deleted correctly and both switches work and the parking brakeswitch works...if the tors was bad it wouldn't even start that has nothing to do with it

?what does this mean? tors was deleted but the switches work???? im have a hard time decifering what this means,can you explain it better? thank you :)
 
Last edited by a moderator:
it started but wont rev and the tors was deleted correctly and both switches work and the parking brakeswitch works...if the tors was bad it wouldn't even start that has nothing to do with it

?what does this mean? tors was deleted but the switches work???? im have a hard time decifering what this means,can you explain it better? thank you :)

Well I deleted the tors then checked the switches and so I know there good and we u ndeleted them
 
Last edited by a moderator:
Cdi is rarely the problem.
It's probably
Parking break
Tors
Stator is junk
Carb needs a good cleaning since it was in water
Clean air filter
 
Okay and parking break is good tors is good filter is clean carb was clean....

Carb was clean.... Make sure that carb is clean and free of water! Also i would leak test it becuase i had one that had a cracked cylinder which caused it not to revv