Rim and Tire Fit

[hoyt08]

Hi i'm looking at getting some 9" rims for my stock blaster, it has the stock axle and swingarm. Would the 9" rim fit? They would be with a Duro DI2011 size 20x11x9 tire. Thanks, Ben

 

[Cochise]

yes they will fit no problem. A better alternative is to score a set of Banshee/Warrior rear hubs and aset of stock Banshee/Warrior/YFZ450 rear wheels.

 

[blasterdude14]

yes as cochise said they will fit
just make sure the bolt patterns are the same

 

[hoyt08]

they won't rub the black plastic piece that is behind the footpeg?

 

[Cochise]

Shouldnt. Stock 21 inch tires clear them.

 

[hoyt08]

But thats only on an 8" rim, i guess it depends on if the rim has the same inside thickness, basically if the extra inch will be on the outside or inside.

 

[blasterdude14]

But thats only on an 8" rim, i guess it depends on if the rim has the same inside thickness, basically if the extra inch will be on the outside or inside.

i dont think it matters either way a 22 inch is 22 inches no bigger no smaller

 

[xjma]

diameter won't mean sh*t in terms of spacing left to right. the stock wheels are 8" wheels, but that refers to the diameter....they also happen to be 8" wide. Wheels are generally referred to in terms of diameter, and the width is usually listed second, or not listed at all. Stock wheels are 4+4, meaning the mounting surface is right in the center. if you got 8" wide wheels with 3+5 then you could either make them suck the tires in an inch on each side or push them out an inch. that being said, my 22x11-8 mud lites on stock wheels didn't rub except they'd hit the enge of the metal that wraps around the tire when taking a hard turn, and that's it. Spacers fix it.