So I've been wondering about this wobbly front tire, and tonight I took a little time to check it out......NOT GOOD. Well, the wobbly tire was okay, other than a bad outer wheel bearing (inner bearing was ok)...anyone care to enlighten me on how to get that sucker out? I tried hitting from the inside to drive it out...nada. I tried hitting from the outside to drive it in...nada. Of course, I wasn't beating the living spit out of it either, but my lord, I was never any good at the trick boxes that only the owner could get open. Anyhow, to figure out what the deal was, I also removed the other wheel...inner bearing is totally shot, I'm suprise the wheel even spun. The inner bearing, lol, all the balls have completely flattened and welded themselves to the adjacent one, surprisingly though, the outer bearing on that side was fine. I inspected the spindles and the bearing journals, they are all fine, no warpage in the journals and no visible wear on the spindle. I even took the other inner "better" bearing and slid it on, just to make sure and slid on and off and there was no gap between the inner race and the spindle. The wheel hubs measured 109.5mm, lettering cast into the hub said maximum diameter of 111mm, so I'm good there. Just need to get those bearings out. Thanks for, yet again, any help you offer up.