Reeds

[bundyho1]

Well after checking just about everything and ordering flywheel puller and holder,it was the reeds.:"> It has v-force3 reeds in it.When i went to take them out one of my reeds just fell out.The other one is really loose too.The inner ones look like they are tight.Why is the outer reeds so loose.They where all chipped up too.Any info on where and how to install?

 

[bundyho1]

Ok just saw the problem.The part that goes into the vforce 3 reed cage with the reeds goes down into it a little.So when i put the backing up against it(Carburetor Joint) it has space between the inner piece of the vforce3 reeds and the carb joint.It moves around in there a little.Is there supossed to be a rubber gasket on the inside of the carb joint that sticks out far enough to put pressure on the vforce3 reeds?If not anybody got any ideas that i can do to fix this?A inner rubber gasket?

P.S. Also the regular gaskets are not going to work.