Haha that's funny. Hopefully you spend a ton on them. Did you get those heel guards painted yet?
Ready to ride
- Thread starter pudvah
- Start date
They were only like 10. No man I actually just got my Dremel and oscillating tool so I can sand them and paint. One of the bolts that holds the cover on is completely rounded too so I have to figure out how to get that off so I can put the new one on, I already have it modified so I can put Kens case saver on there. Hoping to get this done this week. Oh I still have to put dual bearing chain rollers on too.
i have a left foot peg that is not bent
if intrested 15 bucks....11-12 bucks to ship it and 2 3 bucks for my effort lol
if intrested 15 bucks....11-12 bucks to ship it and 2 3 bucks for my effort lol
I'm ready to roll man, got my tors removal kit in the mail today with motion pros throttle cable and fmf silencer packing. I have a lot of work to do but once everything on I will have a friggen 2015 Blaster lol
Yes that thing on the end is normal
It's made so the gas doesn't spray around. I had that problem when I was 6 I think. We lost the hose and I kept getting sprayed by gas. Which doesn't smell or taste that good
It's made so the gas doesn't spray around. I had that problem when I was 6 I think. We lost the hose and I kept getting sprayed by gas. Which doesn't smell or taste that good
some off those types have a problem with not letting it vent properly.
so keep an eye on it...most have had great success though
picture sucking on a soda bottle and never letting up for air=crush no flow lol
so keep an eye on it...most have had great success though
picture sucking on a soda bottle and never letting up for air=crush no flow lol
that new cap has very small holes on the underside to allow fumes out/air in to prevent a vapor lock, and a little ball inside so if flipped, it blocks off actual fuel coming out.
the stock vent just routed up and down thru the dash and vented to free air down beside the steering stem,
the one way valve to prevent spillage is in the cap itself on a stock set-up
Sounds like a good system, now only if the thing would have fit lol. Friggen China, no wonder it was 6 dollars. Anyone have a little chinese kid 4 wheeler ? I'll send it for free.
I thought that looked small in your hand, but figured it was just the pic
careful with buying parts from foreign countries, there was a 250 4 stroke blaster (knockoff) sold overseas,
maybe that was for it ?
Ya I figured I would have taken the gamble for a few dollars. On a good note I got the dual bearing chain rollers on today. Have to loosen the chain some it's too tight put the new petcock on tors delete kit heat cycle re torque and will be good. Only have an hour a night though so it will take a few days.
Plus I bought a sh*tty dremel I got one post cut off and had to recharge the damn thing. I'm kinda confused on the chain slack. When sitting on the quad I can pull the chain up about half inch but it's not slack it's tight but can still pull it up. Is that how it's supposed to be or should there literally be slack there. Idk kinda hard to explain
Ya I know how to loosen and tighten just confused on how hard you pull to measure the slack. The chain is pretty tight but I can still pull it up half inch by pulling on it
With the rider (you) sitting on the atv, there should be about 1.5 inch of slack. I believe manual said 40-60 mm??
let someone else confirm those haha
let someone else confirm those haha
