Raptor Spindle???

[delbow]

Does anyone know if the raptor utilizes the same 12 degree taper ball joints as the warrior and banshee. Also is the actual spindle the same as banshees and warriors (will banshee/warrior hubs fit raptor spindles)?
Thank you gentlemen..
-Dan

 

[Blaner]

i found the raptor 660 spindles to use a different bal joint location angle when i did my 450 front suspension setup. had a set of banshee spindles but they made the ball joints sit under too much stress leaving no room for movememnt, so i got some 660 spindles and they worked perfectly.

the 660 ones are also one piece alloy while the banshee and blaster ones are steel.

I am unsure of the taper angle figures however.

 

[GunBlast]

if raptor spindles were used on aftermarket arms (knowing the upper balljoints would be cocked at a severe angle or not seated properly) if it would give you more negative camber (top of tire leaning in) than shee or warrior spindles?