please help
- Thread starter blaster7
- Start date
tors will make it rev high it happend to me i took out the spring amd it works great now and i got a new air fuel screw
yeah it has no tors,also I'm wanting to run the keihin pwk ysn 30 that's what I was asking what size jetting should I get,here's the problem I have it will not idol at all and at high rev it sputters,the jets it has now are main:155-pilot:53 now I have the stock carb that's jetted for the 240 big bore and it's the jets that came with the 240 here's the jet sizes main:340-pilot:32.5 with the stock carb It seems to run good and no the stock carb doesn't have tors and I run pre mix 32.1 I run red line synthetic,so what I need to know is what size jets do I need for the keihin carb and if you guys think that that carbs good for my whole set up as far as the engine go's,again thinks for all your help 
Actually TORS do the opposite. What it does it limits ur rev incase what happened to u WONT happen. Basically making ur bike cut off or bog out. Read the tors diy
guys any help would be nice,I'm going to be ordering the jets soon so I would like to know what to get also thanks for any help.
also thanks for any help.
im not familiar with the carb u got so i dont wanna give u the wrong advice. ur problem could be many things man. maybe ure too lean. sound like u are. get some bigger jets and work ur way down from what i was told on my carb prob one time. then start do them plug chops. u'll need a few plugs. although i STILL dont understand plug chops i only do a visual check of the plug after a hard run. or, it could be a dirty ass carb. u should always clean out ur carb when u have it off anyway, and check ur reeds but put a finger inside the intake and feel for any missing sh*t or loose things dont force ur finger around bc u might break the reeds. thats all the advice i have man hope it helps
ok guys I've got another question,where can I get a throttle cable for my push throttle that can hook up to my keihin pwk,thanks for any info.
ebay.. a regular tors delete cable works too, thats what i use and its been good to me.
no i don't think that'll work bud because the tip of the cable is to fat on the stock blaster cable,I have a flat slide carb so I need a cable that will work for that slide and that will hook up to my stock push throttle,again thanks for any help guys.
Similar threads
