pipe?

[LUISFER764]

I have a big bore/stroker kit ported for top end, but I have a pipe that I think that is like a f7, ct or something like that. This pipe is not for top end, so should I get a top end pipe, like a lrd? And, would a drag pipe give more top end?

 

[yb200]

an all out drag pipe would be best

 

[yb200]

i know mat shearer is working on a new blaster big bore pipe..

maybe om kennedy he can get you info on that

 

[brandoz28]

if you're just looking for high end, get a drag pipe

 

[yb200]

dont get the drz pipe i hear they suck nut sack

 

[LUISFER764]

Thank you men, I would get one

 

[blasterfreek30]

i would keep the f7....one of the best top end pipes out there

 

[yb200]

i would keep the f7....one of the best top end pipes out there

i agree freek

or go all out with a drag pipe

 

[LUISFER764]

But I feel it doesnt have the enough top end that it should have. Maybe the problem is the compression or something like that

 

[yb200]

But I feel it doesnt have the enough top end that it should have. Maybe the problem is the compression or something like that

that could be man check the compression

 

[LUISFER764]

I think I have a lot of compression

 

[blasterdude14]

well usually with pipes the motor work should match the pipe so your work may not be what works best with the port so you don't get the full power others would have. I think an lrd would be good although I don't know much about them except they are a top end pipe