phragle's clutch?

[blasterman87]

when discribing your clutch you said "spring plate replaced with full disk" what does that mean? im about to upgrade/replace my clutch and i was wondring what you did there and what are the binifits? thanks and btw thats a wild looking blaster you have, whats everyones input on his clutch setup?

 

[pittboss45]

Some kits only offer the fibers all the same inside diameter. This would not require you to install the wave washer.

 

[phragle]

my clutch theory, stock plates stock disks, there is a half width disk in the pak along with a wavey thing (spring disk) to make the clutch less grabby for the inexperienced rider. the clutch is stronger if you replace it with a full size disk. remember to soak the disks for a couple hours in oil first. and properly adjust the internal tension. so stock plates and disks , barnett heavy springs... if the basket is all notched up, replace that too, or your just throwing money away on a new clutch.

 

[92blaster]

how do i adjust this internal tension? never heard of it is that titening the springs down?

 

[phragle]

on the pressure plate theere is a locknut, losen that and adjust the rod until the clutc arm is pointed at the raised part of the case.

 

[Braapbraap95]

what oil do you soak the plates in?

 

[phragle]

same oil you put in the tranny

 

[Braapbraap95]

also how much and what kind of lowerend oil should I use?

 

[phragle]

I use amsoil 80 wt gear oil, it says the fill amount on the clutch cover by the oil fill think it's 650 ml

 

[blasterman87]

can you post a pic of what to leave out? i have a new stock clutch but i want to be sure im leaving out the right things, and also how much do you tighten the springs down to? what spec?

 

[codykeon18]

Some kits only offer the fibers all the same inside diameter. This would not require you to install the wave washer.

Does ne one know of a kit that comes with a full disk instead of a disk with the "wavey thing"?

 

[blaster biotch]

WHEN u pull the plates off u will know it when u see it. it doesnt match any of the other plates or steel disc

 

[codykeon18]

I know what hes talking about I just need to know if anybody knows of a clutch kit thats includes a full disk and not the disk for the wavey thing

 

[blasterman87]

its wavy and has little dimples all over it isnt it? so just take that out and put everything back the same, now what about the springs how much do i tighten them down? thanks guys and girls

 

[codykeon18]

No i think you have to get a disk thats full width cause i think the disk for the wavy thing is a differant width than the others. PHRAGLE TO THE RESCUE!!!

 

[blasterman87]

yup whare you at lol.. damn hes smart with this stuff, he should make a thread with his own ideas for cheap/ easy mods like this, he has alot ....

 

[codykeon18]

Right but thats why he is a world record endurance holder and has been featured in dirtwheels. All the hard work and devotion payed off for him.

 

[codykeon18]

Just a thought but could i use a old disk from my old clutch and put that in with my new clutch in place of the wavey thing and disk for te wavey thing?

 

[pittboss45]

The wave washer has no dimples. It is about 3/16" wide and looks as if it is warped if you lay it on a flat surface. Barnett clutches have all the same size fibers. Do not misplace the washer, you might need it at a later time.

 

[codykeon18]

Thanks alot thats exactly what I needed.