No Spark

[Peter70]

Ive read every post i could find about a blaster not firing, and it seems to be a common problem. Ive replaced the ignition coil, CDI box, and stator. Its a 95, and i just got the new stator in today and it has 5 wires. The stock stator had 4 wires, theres an extra green wire out of the new stator. whats it for?
The on/off switch has been checked and is fine. any other ideas on why the hell it wont start!? it died one day just cruising down the street and never re-fired. about 6 months ago in fact. pleeeease help. thanks

 

[ron89]

it may be your tors.
http://www.blasterforum.com/do-yourself/655-how-remove-your-tors.html
do u have good compression ?..

 

[Peter70]

What is the tors again? i bought the blaster and i think it was stolen. the key switch is unhooked, so there is no key. and the oil injection has been romoved. it was removed properly because it ran for 2 months perfectly fine after i bought it. but there are two wires that come out of the thumb throttle box and they are cut. what are they? TPS?

 

[bigdblaster]

most likely the tors

 

[blasterbum]

yup bro take the tors out also you need to check your compression and make sure you dont need a top end rebuild
thts what happen to me and i found out i was only gettin 15 psi of pressure, i melted my piston rings to the piston lol
so check tht first bro :0)

 

[Peter70]

the tors has already been removed.

what would ow compression have to do with it not getting any spark?

and what does the green wire that comes out of the stator do?
like i said before, i just bought a new stator, and 4 wires match up, but there is an extra green wire that comes off the new stator. whats it for?

 

[fastLANE]

in the elctrical field, green usually stands for a ground wire