new cylinder sleeve

TeamCarr

New Member
Jul 16, 2009
175
1
0
Cocoa,Fl
i am about to have an 02 blaster engine and it needs a new cylinder sleeve. i was looking on ebay and they have a couple different kinds. if i get the Yamaha Blaster Big Bore LA Sleeve Cylinder Sleeve 88-07 will that make it a 240cc blaster?
 
you will need to get the old sleeve removed then they will have to bore the jug to accept the bigger sleeve, then they will have to match the ports on the jug to the sleeve.

i have this setup - i just sent it out to wildcard for them to do their magic on it to open it up. but it will not be as good as a vito's or others that have created a new jug and have the 12 port setup but it will have more power than a stock bore.
 
you will need to get the old sleeve removed then they will have to bore the jug to accept the bigger sleeve, then they will have to match the ports on the jug to the sleeve.

i have this setup - i just sent it out to wildcard for them to do their magic on it to open it up. but it will not be as good as a vito's or others that have created a new jug and have the 12 port setup but it will have more power than a stock bore.

how much did it run you to send it to wildcard and have them set it all up?
 
not sure - it is still in the mail going to them.
it is 140 for them to do the porting work.
but i think it needs it bored / honed / new piston and maybe some head work done.
I sent them my top end to make sure they get it all setup correctly.


Also if you go big bore you will need to get your head bored to work with the larger bore on the cylinder.

if you go big bore let me know i might have a 72mm piston that might have about 10 hours on it - it will need new rings but other than that it is good.
 
  • Like
Reactions: TeamCarr